Toyota Vios 2014 C1515 Torque Sensor Adjustment by Launch X431

After replacing EMPSECU,steering wheel,Inclined steering column,Steering column gear etc. The instrument PS warning light is on,X-431 is read to the fault code C1515- torque sensor zero adjustment is not completed -Current – electronic auxiliary power steering system fault code.Need tooperate torque sensor to adjust the learning flow.So here car-auto-repair.com show you guide on how to use Launch X431 device to adjust torque sensor for Toyota Vios 2014.More Toyota topics,please check here:Toyota Trouble Repair.

Toyota-Vios-2014-C1515-Torque-Sensor-Adjustment-by-Launch-X431-1

What You Need?

Launch X431 Pro

Operation Procedure:

1.Switch on the ignition;

2.Select Toyota V48.80 above.

3.Select 16PIN diagnostic sockets(European and other area);

4.Select auto-search VIOS(VIOS)

5.Select no smart key;

6.Select chassis system;

7.Select system selection;

8.Select chassis;

9.Select electronic auxiliary power steering system.

Toyota-Vios-2014-C1515-Torque-Sensor-Adjustment-by-Launch-X431-2

10.Select Special Function;

11.Select torque sensor adjustment;

12.Note that “this function is used to adjust the position of the steering Angle, when you use this function please press the prompt information”

Toyota-Vios-2014-C1515-Torque-Sensor-Adjustment-by-Launch-X431-3

13.Attention to the operation torque sensor adjustment hint, which is used to determine the steering wheel center, if any of the following parts are replaced:

1) EMPSECU;

2)Steering wheel;

3) Inclined steering column;

4)The steering column gear assembly shall continue according to the “determination” key.

Toyota-Vios-2014-C1515-Torque-Sensor-Adjustment-by-Launch-X431-4

14.Confirm the following:

1)The vehicle is still;

2)The engine does not operate;

3)Ignition switch opens;

4) steering wheel fixed;

5) The vehicle is in a horizontal position;

6) car No non-1515/1581 fault codes are determined

Toyota-Vios-2014-C1515-Torque-Sensor-Adjustment-by-Launch-X431-5

15.Turn off the ignition switch, and then click ok

Toyota-Vios-2014-C1515-Torque-Sensor-Adjustment-by-Launch-X431-6

16.Switch on the ignition, then click”confirm”

Toyota-Vios-2014-C1515-Torque-Sensor-Adjustment-by-Launch-X431-7

17.After the steering wheel stops swinging, press ok to indicate that “correction, remaining ** seconds”

Toyota-Vios-2014-C1515-Torque-Sensor-Adjustment-by-Launch-X431-8

18.The “torque sensor adjustment is completed, the PS warning lamp is closed,” indicating that the sensor learning success

Toyota-Vios-2014-C1515-Torque-Sensor-Adjustment-by-Launch-X431-9

19.Click ok to exit the software; Turn off the ignition switch and restart the vehicle test drive system to restore normal.

More test report about Launch X431 please check:Launch X431 Test report

Be the first to comment

Leave a Reply

Your email address will not be published.


*