Autel MaxiDiag MD808 PRO EPB Safety

This electric parking brake (EPB) function has a multitude of uses to maintain the electronic braking systems safely and effectively.

EPB Safety

It may be dangerous to perform electric parking brake (EPB) system maintenance, so before you begin the service work, please keep these rules in mind.

1.Ensure that you are fully familiar with the braking system and its operation before commencing any work, z

2.The EPB control system OF MD808 may be required to be deactivated before carrying out any maintenance/diagnostic work on the brake system. This can be done from the tool menu,

3.Only carry out maintenance work when the vehicle is stationary and on level ground.

4.Ensure that the EPB control system is reactivated after the maintenance work has been completed.

NOTE:

Autel accepts no responsibility for any accident or injury arising from the maintenance of the 日 ectric Parking Brake system._
EPB Functions

Take BMW as an example

1. Select EPB icon on the Service screen, choose BMW from the vehicle make screen and select the correct vehicle model to enter the Parking Brake menu.

2.A screen shows as below, these three functions enable you to calibrate the parking brake after replacement

3.Workshop Mode
This function provides calibration operations which should be performed after you make some changes on the EPB system

Follow the instructions on the screen to conduct the operation, when the calibration is successfully complete, a “Service function finished” message will appear on the screen. Press OK to exit.

Startup
Select Startup and follow the on-screen instructions to perform a series of operations to start the brake pad after replacement.

When the operation is successfully complete, a “Service function finished” message will appear on the screen. Press OK to exit.

Parking Brake: Bedding-in Procedure

If the brake discs of the brake pads are replaced, this function should always be carried out to improve the friction values.

Follow the on-screen instructions to perform this function, when the operation is successfully complete, a “Service function finished” message will appear on the screen. Press OK to exit.

THIS ARTICLE IS PUBLISHED BY Youobd2.com