KESS V2 5.017 KSUITE 2.53 “EXTERNAL EXCEPTION EEFFACE” ERROR SOLUTION

Customer problem: When I run Ksuite 2.53 on my KESS V2 Master, a message error appeared on the screen “External exception EEFFACE”. I tested with another cable and tested on another port… but the results were always the same. It is normal for the computer to detect as usb device. I also tried to take sd card out and put back, and cleaned the sd card and reader contracts, but also failed to solve.

Obd2tool.com engineer replied:

Solution 1: Please try to uninstall the current software and download by the following links.

https://mega.nz/file/Lol0GCZR#nOeibBrssBZGwzzvHAlNozrMV3VkVWIl9P0zBT6dcIo

No password! No risk!

Size: 857.3MB

Link 2: https://share.weiyun.com/5FPSb3H

Password: i4cwgr

Size: 3.71GB

Security: has been tested 100% OK by www.obd2tool.com engineer.

Note: If you choose this download link, you need to scan QQ or WeChat QR code to get authorization to download.

Solution 2: please refer to the solution of kess v2 fw4.036

1. the interface may be destroy/broken if you connected this clone tool to internet, or update online.

1.Desolder the old NPX and change it with a new NPX chip with 60 tokens inside. It cost 13.

14 some users call this chip as CPU Repair Chip, available at: -20USD

Note: NPX is out of stock in some sites now, because the newest KESS V2 need not replace NPX, the NPX is preinstalled in the machine .

3.–or you have to weld a connector on backside of interface ,and plug the J-link programmer.
You can reset the Kess v2 to virgin. obd2tool is available with J-link V8, cost about 20USD, user can buy at:

Note: the newest KESS V2 V2.06 is packed with J-link V8 programmer, no need buy additional one.

How to use j-link v8 to solve Kess V2 master tokens limited problem:

Step 1. Buy one LPC2478 chip to replace the original one for KESS V2 master.

Step 2. Prepare for a LINK J-LINK V8 ARM USB-JTAG Adapter Emulator.

Step 3: weld a connector on backside of interface.

KESS-V2-5.017-KSUITE-2.53-“EXTERNAL-EXCEPTION-EEFFACE”-ERROR-SOLUTION-6

Step 4: plug the J-link programmer

I hope it can solve your problem.