How to use MUT-III to Register Mitsubishi Outlander 2007 Immo Key

Your Mitsubishi key fob makes securely accessing your vehicle hassle-free. However, what if you are out and about in Orlando when you press the button on your Mitsubishi key fob and nothing happens? Don’t worry! It is easy to change a battery in Mitsubishi key fobs and to program a key once again. Learn how to program a Mitsubishi key fob and more with the team at Longwood Mitsubishi.

How to Change a Battery in a Mitsubishi Key

If your Mitsubishi key fob isn’t working properly, a dead battery is likely the culprit. That is why it is important to know how to change a battery in a Mitsubishi key. Simply follow the steps below and get back on the roads of Sanford in no time.

* Locate a flat-head screwdriver or a plastic electronics opening tool and a new 2032 battery.
* Take out the key in your Mitsubishi key fob.
* Locate where there is an indentation at the top of the fob.
* Use the screwdriver or opening tool to pry the fob open.
* Take out the old battery and properly insert a new one.
* Put the fob case back together and press it firmly to close.
* Reinsert the key.

How to Program a Mitsubishi Key Fob

If your Mitsubishi key fob happens to lose connection with your vehicle, you will need to know how to program a Mitsubishi key fob. The Mitsubishi key programming instructions listed below can help. It only takes a few minutes to learn how to program a Mitsubishi key fob when you follow these directions:

* Hold down the lock and unlock button at the same time. The lights will flash three times.
* Let go of each button.
* Push the unlock button until the light flashes two times. This will sync the car and your Mitsubishi key fob.
* Test the key fob to ensure it is functioning as intended.

How to use MUT-III to Register Mitsubishi Outlander 2007 Immo Key

Recently I registered keys for Mitsubishi Outlander Classic 2.4L AT 4G69 2007Y. It was necessary to add 1 key. Everything was done with Mitsubishi MUT-II diagnostic scan tool.

Disclaimer: The tutorial was translated from Russian. So the menu is in Russian, but have English explanation.

Run the software MUT 3 , select STV (Scan Tool Viewer):

Go to the System Selection menu:

We put the year with 2005 , we enter the VIN-number, we get the active configuration, and we go further into the Immobilizer :

Let’s go to the list of data:

We see 2 registered keys:

We go back to the menu, go to a special function:

Registration of ID-key :

We enter the password and agree:

We see on this screen, the 1st key is already inserted in the ignition lock, we agree:

1st key registration successfully after 10 seconds, turn on the ignition with a second key, preferably do it quickly, we agree with the question of the registration of the following key:

The second key is registered, we repeat the same thing for the third key:

The third key is registered, because there are no more keys for registration, cancel the addition of the next possible key:

We go back and go to the data list, now we see 3 registered keys:

We go into self-diagnosis, no errors are found, then everything is ok:

Alternately we start the engine of the car with each key, we make sure that all 3 are registered, they work:

Be the first to comment

Leave a Reply

Your email address will not be published.


*