MB STAR | chinaobdtool.net

There is no slider selected or the slider was deleted.

How to Update XENTRY Diagnosis VCI Firmware

November 8, 2021 Eva 0

After an update to the XENTRY Diagnosis Pad 2, you may then need to update the firmware for the Xentry diagnosis VCI. You can also […]

Mercedes-Benz Oil Reset by MB Star Tools & Xentry Diagnostic Software

October 28, 2021 Eva 0

Model: Mercedes-Benz CLA 118 Purpose: Oil Reset What we need: MB Xentry software and SDconnect C4. Oil Reset procedure: Step 1. Scan First, we select […]

Xentry Passthru Download, Comparison, Adapter List and Review

October 8, 2021 Eva 0

What is Xentry Passthru: XENTRY Pass Thru EU is Mercedes-Benz vehicle diagnosis solution for independent workshops. The software runs on any workshop PC and commercially […]

Xentry“Supplied StarKey is invalid” -Solution

September 24, 2021 Eva 0

Recently we get a message from our customer, for SDC4 software error message “Supplied StarKey is invalid” as following, firtsly we try to activate again, […]

DOIP SD C4 PLUS vs vxdiag Benz C6 vs sdconnect c5 vs BENZ ECOM

September 22, 2021 Eva 0

All of the above Mercedes Benz diagnostic and programming tools are compatible with the DOIP protocol, DOIP SD C4 PLUS (SP100-E) is highly advised because […]

How to fix VXDIAG Benz C6 Xentry Diagnosis Connect Device Error

August 2, 2021 Eva 0

When I open XDVCI Update V3.3 to run Xentry Diagnosis VCI Update, it gave me error: connect device error: ping failed 192.168.4.1. I have VXDIAG […]

How to update MB SD Connect Compact 5 /SD C4/ SD C4 PLUS

June 25, 2021 Eva 0

This post comes with the introduction to update MB SD Connect Compact 5 /SD C4/ SD C4 Plus. Step 1: Change file name There are two […]

How to Install SD Connect C4 multiplexer batteries

June 11, 2021 Eva 0

Mercedes SD Connect C4. Install the batteries. When installing batteries follow the correct polarity according to the image: It is recommended to operate the multiplexer […]