Scania VCI3 SDP3 V2.34 download, install, activate

Scania SDP3 V2.34 download:

No password
100% tested no issues
Works perfect

SDP3 V2.34 install:
Please refer to Scania SDP3 V2.31 video first.
Windows 7 or 8 will be better.
Require Netframework 4.5 installed on system.
In order to install SDP3, administrator rights are required.
Note:The USB key and VCI must not be connected to the computer during the installation of SDP3, especially not if SDP3 is installed for the first time.
The communication problems related to Windows 8 is now solved. Some problem solving reconfigurations was made Thursday the 16th of October.

Scania SDP3 V2.34 activation:
Cost: FREE
After SDP3 software activation, you can use Scania VCI3 or VCI2 with it for
Check and adjustments
Fault Codes
Fault Reporting
Programming of Control units

ECU data modification:

*   EMS – Engine management system.
*   GMS – Gearbox management system.
*   RET – Retarder system.
*   AWD – All wheel drive system.
*   CLS – Clutch Control.
*   EEC – Exhaust Emission Control.
*   COO (COO7) – Coordinator.
*   BWS (BCI1) – Bodywork system.

Resolving trouble codes:

*   EMS (S6, S7, S8).
*   GMS (OPC4, OPC5).
*   RET (RET1, RET2).
*   AWD (AWD1).
*   EEC (SCR1, EEC3).
*   COO (COO6, COO7).
*   HMS (HMS1).

Some interesting options:

*   AdBlue ON/OFF.
*   Chassis ID/VIN Change.
*   Immobilizer ON/OFF.
*   Truck Power INCREASE.
*   ECU Recovery.
*   ECU Reset.
*   ECU Unlock.


Be the first to comment

Leave a Reply

Your email address will not be published.