Engine Control Module Recovery by GMMDI or Tech 2

This is step-by-step instruction on how to do engine control module recovery on Cadillac cars by obd2tool.com

modules tested successfully with the tools and guide below:
2009 Buick Enclave 2007-2009 Cadillac CTS, SRX, STS 2009 Chevrolet Traverse 2007 GMC Acadia 2009 GMC Acadia 2007 Saturn OUTLOOK 2009 Saturn OUTLOOK

Diagnostic tool:
GM MDI module/
GM Tech 2 Scanner

Engine control module recovery procedure:
1.Disconnect the programming device.
2.Power down the control modules connected to the GMLAN bus by disconnecting the positive battery cable for 2 minutes.
3.Reconnect the positive battery cable.
4.Determine which programming device will be used to perform the recovery steps.
If using MDI, connect to the programming station or Notebook using a cable (LAN). Proceed to Step 5 and then Steps 6-8.
If using a Tech 2 proceed to Steps 6-8.
5.Reboot the programming station or Notebook. This is to make sure nothing is in memory. OBD2 Note: Selecting Replace and Reprogram from the Select Diagnostic Tool and Process Screen is REQUIRED because some of the calibrations may be erased from the initial attempt to reprogram the module.
6.Reprogram the engine control module. Select Replace and Reprogram from the Select Diagnostic Tooland Process Screen.
7.Follow the on-screen instructions to complete the programming event.
8.Clear all DTCs using the GM Tech 2 or GDS.

Someone said Tech 2 clone fail to reprogramming the PCM. The Tech 2 will program the PCM for GM approved changes like manual to auto tranny, etc. when swapping PCMs or modifying the car. Even the clones can do it. You just need to use the TIS 2000 software that either comes with it or can be bought separately for about $20-30 dollars. This software is used with a computer to interface with the Tech 2.